Murals are a unique way to transform a room or wall. They are commonly found in resorts, boutiques, gyms, restaurants, and residential homes. Peel & Stick murals should be applied to a flat, smooth, non-textured surface. This step by step guide will show you how to easily apply removable wall murals, custom cuts, and techniques for simpler, accurate installation. See our wall mural collection.
What You Will Need
- Step stool
- Laser level
- Handy Scraper - Click here to see why a Handy Scraper is essential
- Hand towel
- Painter’s tape
For the best results have 1-2 people hanging the Removable Wall Mural working left to right
Prep Your Wall
We suggest wiping the wall with a microfiber cloth even if it appears clean, as this will help tremendously with the adhesion of the removable wall mural. Measure the desired location for which the wall mural will be hung. Lay out each panel starting from left to right (each panel is numbered on the top of the back). Locate any obstructions such as doors, windows, outlets, and light switches.
If you are hanging from the ceiling or molding, skip this step - With a pencil, mark guidelines on the wall where the top of the Removable Wall Mural will be hung. Using a level or laser guide, create a straight, even line that is parallel to the floor.
Install the Removable Wall Mural
Start by hanging the first panel on the far left. At the top of the panel, peel back the plastic film about 3-5 inches, exposing the adhesive side. For best results, be sure to peel back the same amount of the left and right side of the panel. Apply the top of the mural under the ceiling, molding, or level line. With firm pressure in the center, push outward to remove air pockets for a smooth application.
Let the panel hang and slowly peel back the plastic covering about 5-12 inches exposing the sticky adhesive. Use the Handy Scraper to apply the wall mural in a vertical motion, pushing out any air pockets for a smooth adhesion. Slowly and steadily work your way down. If you choose to use a hand towel to attach the mural, swipe horizontally back and forth. Slowly and steadily work your way down.
To line up the next panel, eliminate gaps, overlays, and the panel shifting by taping the mural down using blue painter's tape — repeat application.
Gold or Silver Leaf
Use the sponge brush to apply a thin layer of glue onto the mural (to prevent dripping). Allow the glue to sit for 15-60 minutes. Press the gold leaf to the tacky glue.
Custom Cutouts
During installation, if the mural extends onto a window or door, use a ceramic utility knife and trim down the overlay. If there is an outlet or light switch, remove the cover plate before installing the mural. Hang the panel as usual. When you reach the outlet or light switch, slowly cut out the area and keep applying the mural. If you are finding it hard to remove air bubbles at your cutout site, try a small 45 degree cut on the corner of the cutout.
When installing under a window, measure from the bottom on up and precut your mural before installing.
